How can I use eTomi behind my D-Link DSL-500/504 Router?

Step 1
Open your web browser and enter the IP address of your router (Usually 192.168.0.1).

Click "Login to the web-based management module"



Step 2

• Enter user name and password. (If you have not changed them, the user and password are both admin).
• Click OK

Step 3

Click "configuration", then "port redirection"


Step 4

• Make sure state is enabled
• Set protocol to TCP
• Set start and end port to the port that eTomi is using
• Set Local IP Address to the IP of the machine you want to run eTomi on.
• Click Add, then Apply.
• Make sure state is enabled
• Set protocol to UDP
• Set start and end port to the port that eTomi is using
• Set Local IP Address to the IP of the machine you want to run eTomi on.
• Click Add, then Apply.

Step 5
Click "save changes and reboot". The router will now restart with the new settings.

Step 6 (optional)
To reduce the chances of your router disconnecting under heavy load, you can make additional tweaks to the settings, if you desire.

Go to Configuration > IP Masquerade Timer

• Set the TCP timeout value to 5 minutes
• Set the UDP timeout value to 1 minute

Click OK, and then "Save changes and reboot"