How do I configure my router to use eTomi ?

You must open ports on your router to allow incoming traffic while using eTomi . In the eTomi software, Click on Tools > eTomi Settings > Connection (under Internet).

Under Inbound Address, Select a port between 1028 and 65535 (default is 6346). Make sure Random is not checked. Under Options, check the box I can accept incoming connections.

· Download the latest version of eTomi here

· How can I find the IP address of my computer?

Click on your router below for configuration steps:

· DI-514, DI-524, DI-604, DI-614+, DI-624, DSL-604+

· DI-704P (revC), DI-704UP, DI-714P+, DI-754, DI-764, DI-774, DI-784

· DI-704P (revB), DI-707P

· DI-704P (revA), DI-704, DI-707, DI-711 (revA), DI-713, DI-713P

· DI-804HV, DI-808HV, DI-824VUP

· DSL-500 (Gen2), DSL-504 (Gen2) (Both not supported in USA)

For the DI-5xx, DI-6xx, DI-704P (revC), DI-704UP, DI-754, DI-764, DI-774, DI-784, DI-804HV, DI-808HV, and DI-824VUP:

Step 1 Enter the IP address of your router in a web browser (192.168.0.1).

Step 2 Enter your username (admin) and your password (blank by default).

Step 3 Click on Advanced and then click Virtual Server.

Step 4 Click Enabled and then enter a Name ( eTomi for example).

Step 5 Enter the IP address of the computer you are running eTomi from in the Private IP box. Select Both for the Protocol Type.

Step 6 Enter 6346 in the Private and Public Port boxes. Click Always under schedule or set a time range. Click Apply.

For the DI-704P (revB) and DI-707P:

Step 1 Open a web browser and enter the IP address of your router (192.168.0.1). Enter admin for your username and then your password (blank by default).

Step 2 Click on the Advanced tab and then click Virtual Server on the left side.

Step 3 Enter the following information:

• Check the box next to Enable.
• Next to Service Ports, enter 6346.
• Next to Service IP, enter the IP address of the computer you want to use eTomi from.
• Click Always next to Schedule or enter the time frame that you want.

Step 4 Click Apply and then click Restart to save your changes.

For the DI-704, DI-704P (revA), DI-707, DI-711 (revA), DI-713, and DI-713P:

Step 1 Open your web browser and enter the IP address of the router (192.168.0.1). Enter user name (admin) and your password (blank by default). If there is only 1 box, enter admin.

Step 2 Click on Advanced at the bottom and then click Virtual Server.

Step 3 Create a new entry:

• Enter 6346 in the box under Service Ports.
• Enter the IP address of the computer you want to run eTomi from.
• Check the box under Enable.

Step 4 Click Save and then click Reboot.